Delivery crews set the box in place and leave. Whatever needed connecting, leveling, venting or converting is still waiting when they drive off. We finish that part across Centennial, on refrigerators, laundry, ranges, wall ovens, cooktops, range hoods, wine coolers, built-in ice makers and garbage disposals. The full list is on our appliance installation page.

The Alcove Problem in Older Centennial Kitchens

In Southglenn and Willow Creek, many houses were built in the 1960s and 1970s around appliances that no longer exist. Refrigerator alcoves were framed for units roughly thirty inches wide and shallower front to back than almost anything sold today.

A modern replacement often fits the opening on paper and not in the wall, because the door needs clearance to swing and the coils need air behind them. That is worth establishing before delivery day rather than with a crew standing in the kitchen. The same applies to dishwasher bays cut for shallower machines and to wall oven cutouts in their original dimensions.

Laundry on the Lower Level

Split-level houses across the older half of the city put the laundry downstairs with a long horizontal vent run to the exterior wall. That run matters when a dryer goes in: a new machine on an old duct inherits whatever restriction was already there, and the first no-heat call follows sooner than it should.

We check the vent as part of the installation and handle dryer vent cleaning where the duct needs clearing. In the newer eastern neighborhoods, Piney Creek and the Smoky Hill area, the connections are usually straightforward and what we find instead is a shutoff valve or supply line untouched since the house was built.

How an Installation Call Works

Tell us the appliance and the address when you book, and we will confirm a two-hour arrival window. The technician checks the connection, levels and secures the unit, tests it under load and takes the packaging away. For a gas range or a hard-plumbed line, the connection gets leak-checked before we leave.

If the old appliance turns out to be repairable rather than finished, we say so, and appliance repair in Centennial runs through the same technicians. Call before the delivery date where you can, especially in the older neighborhoods. Every installation carries a 100-day warranty on parts and labor.

Centennial Installs, From Walnut Hills to Saddle Rock Ranches

In the 1960s houses of Cherry Knolls, Walnut Hills and Ridgeview Hills, the work behind the appliance often matters most. Switching a gas dryer to electric needs a 240V circuit the laundry may not have. An older three-prong dryer outlet has to be matched with the right cord, and we confirm that before the old machine leaves.

Gas ranges in those kitchens deserve the same care. The flexible connector and shutoff behind a decades-old range are worth replacing along with it. We connect the new range, level it against the counter and leak-check the line before we leave.

Range hoods are the other venting question on the west side. In a 1960s or 1970s kitchen the old hood may be recirculating or tied to a small duct. A stronger new hood needs a duct sized to match, and we check that before the old hood comes down.

Tri-levels change the delivery path. In The Knolls, Hunters Hill and the tri-levels of Southglenn, a new washer or refrigerator often has to turn on a half-flight landing. We measure stair width and landing depth along with the opening, because a machine that fits the room can still stall on the stairs.

Piney Creek, the Village of Four Lakes and Homestead in the Willows, built between the mid-1970s and the 1990s, are usually on their second round of appliances. Smoky Hill, from the same era, follows the same pattern. A frequent upgrade across these neighborhoods is a larger French-door refrigerator with an ice maker, which needs a sound water line where the old unit may have had none. We run a new refrigerator water line or replace an old plastic one, since that connection is the one most likely to leak later.

Foxridge, built over several decades, can go either way, so we ask the year of the house at booking. Before delivery day, send us the model number and a photo of what sits behind the old unit. That photo answers most questions about cords, valves and vents, and it is the fastest way to avoid a second trip.

Heritage Greens is gated, so delivery and installation both need gate access arranged ahead of time. Tell us at booking and we plan our window around the retailer’s delivery, so the unit is not left waiting in the garage. Gate codes and delivery windows are easier to settle a day ahead than on the driveway.

The custom-home enclaves in the east, Chenango, Chapparal and Saddle Rock Ranches, bring built-in and panel-ready work. A built-in refrigerator or wall oven has to match its cutout and its support. A panel-ready dishwasher needs its custom panel mounted and lined up with the cabinets beside it. Those visits take longer, and every installation carries a 100-day warranty on parts and labor.

When to Call Wilson & Myers

Call before the appliance arrives rather than after. In a house built before 1980, measure the alcove depth as well as its width, and measure the doorway the box has to come through. If the connection has not been touched since the house was built, assume the valve and supply line need attention along with the appliance.

Book an installation and we will confirm the next available window for your Centennial address.