100 day warranty
Installed, Tested and Covered
Every installation we complete in Longmont is covered for 100 days on parts and labor, and gas and water connections are leak-checked before we leave.
Book onlineAppliance Installation in Longmont, CO
Delivery crews set the box in place and leave the connecting, leveling and venting for someone else. We finish that part across Longmont; the full list is on our appliance installation page.
What Installation Runs Into Here
In the East Side and West Side historic districts, installation means houses built long before current appliance sizes: narrow doorways, kitchens fitted into existing rooms and electrical service extended over a century. Measure the path in as well as the opening.
Across the modern majority of the city, openings are standard, and the work is replacing appliances from the 1990s and 2000s along with the original valves and supply lines behind them.
How an Installation Call Works
Tell us the appliance and the address when you book, and we will confirm a two-hour arrival window. The technician checks the connection, levels and secures the unit, tests it under load and takes the packaging away. Where a dryer vent is restricted, we handle dryer vent cleaning in the same visit.
If the old appliance turns out to be repairable rather than finished, we say so, and appliance repair in Longmont runs through the same technicians.
From Longmont Estates to Somerset Meadows: Installing in Longmont
Each part of Longmont asks something different of an install. Here is what changes as you cross town.
The 1960s and 1970s Ring
Longmont Estates, Southmoor Park and Lanyon Park were built in the 1960s and 1970s. Their kitchens were cut for the machines of that time. A dishwasher opening may be a little short for a modern tall-tub model. A wall oven cutout from that era rarely matches a new oven exactly, so check the new unit’s cutout dimensions before ordering.
Laundry in these houses brings its own checks. Older dryer outlets are often the three-prong type, while many new dryers expect a four-wire cord. We fit the cord that matches the outlet on the wall and tell you if the circuit needs an electrician. Gas dryers and ranges get a new connector, and every connection is leak-checked.
Townhomes, Paired Homes and Apartments
Hover Acres, Mill Village and Lanyon Park mix houses with townhomes, paired homes and apartments. Where laundry sits in a closet, a stacked pair or a compact washer may be the only fit. Measure the closet depth with the door closed, and leave room behind for hoses and the vent. For upper-floor units, mention the stairs and turns when you book.
Prospect New Town
Prospect New Town works differently from the rest of the south side. Houses face the street with porches, and garages sit on the alleys behind. Tell us which way the appliance should come in, because the alley route through the garage can be easier than the front steps.
The Newer Southwest and East Side
In Clover Basin, Renaissance and Somerset Meadows, most appliances are still the builder’s originals or their first replacements. The same goes for Sandstone Vistas on the east side. The common upgrade is a larger refrigerator with ice and water, and two questions decide it: does the opening allow it, and does a water line reach that wall.
We connect to an existing line and shutoff, and we test that shutoff before disconnecting the old unit. Where no line exists, we tell you before the visit rather than at the door. Counter-depth models need the cabinet depth confirmed too, since a door that will not open past a wall corner is a common surprise. A builder-grade dishwasher coming out after ten or more years also gets a fresh supply line, not the original one.
The Historic Districts
The Historic Westside has larger houses on larger lots than the Historic Eastside. Where a kitchen there has been rebuilt around panel-ready units, the custom panel is fitted at installation, so have it on site when we arrive. In both districts, a gas range swap starts at the shutoff, because a valve that old does not always close fully. We check it, fit a new connector and leak-test before the range goes back.
When to Call Wilson & Myers
Call before the appliance arrives rather than after. Measure the doorway the box has to come through, not just the opening it is going into, and measure cabinet depth as well as width.
Book an installation and we will confirm the next available window for your Longmont address.
Appliance Installation in Longmont: Common Questions
Do you handle gas connections?
We connect gas appliances and leak-check the connection before leaving. Where a job needs a new gas line run or work that belongs to a licensed gas fitter, we tell you at the diagnostic rather than partway through.
Do you take the old appliance away?
We take the packaging, and we can disconnect and move the old unit out. Tell us when you book so the technician arrives expecting it, because removal changes how long the visit takes.
Which parts of Longmont do you install in?
All of 80501, 80503 and 80504, the last two shared with neighboring communities, across the East Side and West Side historic districts, downtown, and the newer subdivisions around them. Neighboring Erie, Lafayette, Brighton, Broomfield and Boulder are in the same dispatch zone, inside the Denver Metro Area we cover.
New Appliance to Install in Longmont?
Tell us what the machine is doing and we will confirm an arrival window that suits you.
