The delivery truck brings the machine to the kitchen floor and leaves. What happens next decides whether the appliance works properly for a decade or leaks quietly behind a cabinet for a year. Wilson & Myers handles the connection, the venting, the water line and removal of whatever the new unit replaces.

What We Install in Aurora, CO

Connections, venting and water lines for new appliances, plus removal of the old unit when you need it gone.

Washer Hook Up

Supply lines, drain connection and level-and-test

Dryer Hook Up

Gas and electric dryers, vent connection and airflow check

Dishwasher Installation

Water supply, drain line, power and cabinet fit

Refrigerator Water Line

New line runs for ice makers and water dispensers

Range and Cooktop Installation

Freestanding and slide-in ranges, gas and electric cooktops

Double Oven Installation

Built-in single and double wall ovens

Range Hood Installation

Ducted and recirculating hoods, mounting and vent runs

Garbage Disposal Installation

Mounting, drain tie-in and switch connection

Delivery and Haul Away

Moving the new unit in and taking the old one out

New Builds and Older Stock Need Different Things

Aurora splits cleanly here. Out past E-470, in Saddle Rock, Tallyn’s Reach, Beacon Point and Wheatlands, the houses are recent: standard rough-ins, predictable clearances, modern electrical service. Installation there is mostly straightforward, and the work is often a first appliance going into a kitchen that was built for it.

West of I-225, in Original Aurora and Hoffman Heights, the picture changes. Laundry spaces were sized for machines that no longer exist, supply valves seize with age, and dryer vent runs were laid for smaller units. We check the connection before committing to the install rather than discovering it halfway.

Laundry and Kitchen Connections

Vent length matters more than people expect. A dryer on a long or crushed duct will run a full cycle and leave clothes damp, and that becomes a repair call three months later rather than an installation problem today. We verify airflow as part of the hook-up.

Dishwashers need water, drain and power in an opening often sized for a different machine. Built-in wall ovens need the cabinet opening and its support checked before the unit goes in, because a double oven is heavy and unforgiving of an opening slightly out of square. Refrigerator water lines are the job most likely to leak later if rushed.

Before the Delivery Arrives

The most useful thing you can do is tell us what is behind the old appliance. Whether the range is gas or electric, whether the laundry pair is stacked or side by side, whether the dishwasher opening is standard width. We ask these at booking so the technician arrives with the right fittings.

If the retailer is delivering, we work around their window. Delivery crews generally set the unit in place and stop there. The connection, testing and removal of the old machine is what we pick up.

Parts, Fittings and Warranty

Hoses, valves, vent kits and connectors come through national supplier networks and manufacturer contracts. Most installations use standard fittings we carry to the job. Where a connection turns out to be non-standard, we tell you what is needed and what the timing looks like before you commit.

Installation work carries a 100-day warranty on parts and labor. The full range of installation services is on our appliance installation page.

From Heather Gardens to Southshore: Installing Across Aurora

In Murphy Creek, Cross Creek, Tollgate Crossing and Southshore, many installs replace builder-grade machines for the first time. The opening usually fits, but the supply valve and hose behind the old unit are often original. We swap a stiff valve or an old rubber hose at the hook-up rather than tie a new machine to it. New refrigerators also tend to run deeper or taller than the builder model, so we check the opening against the cabinet above.

The 1960s and 1970s neighborhoods ask different questions. In Chambers Heights, Hallcraft’s Village East and Meadowood, many bi-levels and tri-levels keep the laundry on a lower floor, so a new dryer inherits a long vent run. Switching a gas dryer to electric there needs a 240V circuit the room may not have. An older three-prong dryer outlet also has to be matched with the right cord, which we confirm before the old machine leaves.

Gas ranges in those houses deserve the same care. The flexible connector and shutoff behind a range from the 1970s or 1980s are worth replacing with the appliance rather than reusing. We connect the new range, level it against the counter and leak-check the line before we leave.

Mission Viejo, Seven Hills and Hutchinson Heights sit in between. Kitchens from the 1970s through the 1990s have often been remodeled once, and a remodel can hide an old supply line under new cabinets. We trace the dishwasher and refrigerator lines back to their valves before anything gets connected.

Condo and townhome pockets are their own kind of job. Heather Gardens, the large 55+ condominium community around East Yale Avenue, and the condo and townhome complexes of Heather Ridge can mean shared entries and tight laundry closets. A closet sized for a stacked washer and dryer will not take a side-by-side pair, so we confirm the space before you choose the machines. We ask at booking how the unit gets from the truck to the closet and whether the building limits delivery hours.

At the top of the market, upscale homes in Tallyn’s Reach are more likely to carry built-in and panel-ready appliances. A built-in refrigerator or a wall oven has to match its cutout and its support. A panel-ready dishwasher needs its custom panel mounted and lined up with the cabinets beside it, so those installs take longer and we plan the visit around that.

Before the delivery date, send us the model number and a photo of the connection behind the old unit. That one photo settles most questions about valves, cords and venting before anyone arrives. Wherever the house sits, the old machine can leave with us, and every installation carries a 100-day warranty on parts and labor. For laundry rooms with a long or crushed duct, our dryer hook-up includes a vent connection and airflow check.

When to Call Wilson & Myers

Call before the appliance is delivered rather than after. A short conversation about what is behind the old unit usually saves a return visit. If the appliance is already sitting in your kitchen, call anyway: most installs happen within a few days.